Subaru Forester 2019-2026 Owners Manual / Starting and operating / Cruise control (if equipped) / To change the cruising speed / To increase the speed (by the “RES/SET” switch)

Subaru Forester: To change the cruising speed / To increase the speed (by the “RES/SET” switch)

Subaru Forester. To increase the speed (by the “RES/SET” switch)

Press the “RES/SET” switch to the “RES” side and hold it until the vehicle reaches the desired speed. Then, release the switch. The vehicle speed at that moment will be memorized and treated as the new set speed.

When setting the displayed unit as “MPH”:

The set speed can be increased 1 mph (1.6 km/h) each time by pressing the “RES/ SET” switch to the “RES” side.

When setting the displayed unit as “km/h”:

The set speed can be increased 1 km/h each time by pressing the “RES/SET” switch to the “RES” side.

To change the cruising speed

To increase the speed (by accelerator pedal)

Depress the accelerator pedal to accelerate the vehicle to the desired speed. Press the “RES/SET” switch to the “SET” side once. Now the desired speed is set and the vehicle will keep running at that speed without depressing the accelerator pedal...

Other information:

Subaru Forester 2019-2026 Owners Manual: Rear seat heater (if equipped)

CAUTION Do not open and close the center console lid while operating the rear seat heater switch. There is the risk of fingers being caught in the lid. The seat heater operates when the ignition switch is in the “ON” position. Rear seat heater switch HIGH mode indicators LOW mode indicators Left-hand side Right-hand side Press the rear seat heater switch...

Subaru Forester 2019-2026 Owners Manual: Fastening the seatbelt. Rear center seatbelt

Center seatbelt tongue plate Anchor tongue plate Anchor buckle Center seatbelt buckle WARNING Fastening the seatbelt with the webbing twisted can increase the risk or severity of injury in an accident. When fastening the belt after it is pulled out from the retractor, especially when inserting the anchor tongue plate into the mating buckle (on right-hand side), always check that the webbing is not twisted...

Driving information display

NOTE

You can set the units for both the multifunction display (black and white) and the combination meter at the same time. For details about setting the language and units, refer to “Type A combination meter” or “Menu screens”.