Subaru Forester: Seat, seatbelt and SRS airbags / Rear seats
Close the driver’s door.
Hold the access key fob and press and
hold the “SET” button, then press the
button on the access key fob.
A chirp will sound, and the registered seat
position will be cleared.
NOTE
After deleting the seat position, wait for
a few moments before registering a..
To lower the armrest, pull down the top
edge of the armrest.
WARNING
To avoid serious injury, passengers
must never sit on the center
armrest.
When using the seatbelt, do not
allow it to become tangled with
an arm rest...
Other information:
Antennas
Operating range
NOTE
If the access key fob is not detected
within the operating range of the antennas
inside the vehicle, the push-button
ignition switch and the engine start
cannot be operated.
Even when the access key fob is
outside the vehicle, if it is placed too
close to the glass, it may be possible to
switch the power or to start the engine...
The exact appearance and installation positions of the sensors may vary depending on the specific Kia Telluride model and equipment configuration.
Front impact sensor
Supplemental Restraint System (SRS) control module/rollover sensor
Side pressure sensors (front door)
Side impact sensor (B-pillar)
Side impact sensor (C-pillar)
WARNING
Air bag sensors
Do not strike, modify, or allow objects to impact the locations where the air bag modules or collision sensors are installed...