Subaru Forester 2019-2026 Owners Manual / Instruments and controls / Light control switch
Subaru Forester: Instruments and controls / Light control switch
- Precautions and tips
- Headlights
- Welcome lighting function
- Sensor for the auto on/off headlights
- High/low beam change (dimmer)
- Headlight flasher
- High beam assist function (if equipped)
- How to use the high beam assist function
- How to temporarily lower the sensitivity of the high beam assist function
- How to change the headlight mode manually
- Tips for the high beam assist system
- Daytime running light system
Regulatory information
The Bluetooth® word mark and logos are
registered trademarks owned by Bluetooth
SIG, Inc...
Precautions and tips
CAUTION
Use of any lights for a long period
of time while the engine is not
running can cause the battery to
discharge.
Before leaving the vehicle, make
sure that the lights are turned off...
Other information:
Subaru Forester 2019-2026 Owners Manual: Hill descent control indicator
Hill descent control indicator (type A) Hill descent control indicator (type B) This indicator appears while the hill descent control function is in the standby mode. It flashes while the function is operating. It will disappear when the function is in the disabled mode...
Subaru Forester 2019-2026 Owners Manual: Rear tie-down holes
Rear tie-down hole The rear tie-down holes are located near each of the jack-up reinforcements. There is a plug in each rear tie-down hole. To use the rear tie-down holes, remove the plugs. After using the rear tie-down holes, return the plugs to their original places...
Categories
- Manuals Home
- How to use the high beam assist function
- All-Wheel Drive warning light
- Daytime running light system
- New on site
- Most important about car
Average fuel consumption
This display shows the average rate of fuel consumption since the trip meter was last reset.
Copyright © 2026 www.suforester5.com