Subaru Forester: Immobilizer / Certification for immobilizer system
- For models with “keyless access
with push-button start system”:
Refer to “Certification for keyless access with push-button start system”.
- For models without “keyless access
with push-button start system”:
- U.S.-spec. models
FCC ID: Y8PFJ16-2
CAUTION
FCC WARNING
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- Canada-spec. models
- Mexico-spec. models
- U.S.-spec. models
Key replacement
Y..
Remote keyless entry system
CAUTION
Do not expose the remote transmitter
to severe shocks, such as
those experienced as a result of
dropping or throwing.
Do not take the remote transmitter
apart except when replacing
the battery...
Other information:
Subaru Forester 2019-2025 Owners Manual: Fastening the seatbelt. Rear seatbelts (except rear center seatbelt)
Sit well back in the seat. Pick up the tongue plate and pull the belt out slowly. Do not let it get twisted. If the belt stops before reaching the buckle, return the belt slightly and pull it out more slowly. If the belt still cannot be unlocked, let the belt retract slightly after giving it a strong pull, then pull it out slowly again...
Subaru Forester 2019-2025 Owners Manual: Programming Two-Way Communication
Status Indicators Within five seconds after programming a new HomeLink button, both of HomeLink’s garage door status indicators will flash rapidly green indicating that the garage door two-way communication has been enabled. If your garage door status indicators flashed, two-way communication programming is complete...
Categories
- Manuals Home
- Subaru Forester Owners Manual
- Subaru Forester Service Manual
- Auto Start Stop warning light/Auto Start Stop OFF indicator light (yellow)
- Alarm system setting
- Illumination brightness control
- New on site
- Most important about car
Driving information display
NOTE
You can set the units for both the multifunction display (black and white) and the combination meter at the same time. For details about setting the language and units, refer to “Type A combination meter” or “Menu screens”.
